I had an old laptop, and my WiFi required some kind of cutter driver that wrapped broadcom, my Intel graphics didn’t work on newer kernels. It booted in 7 seconds on a 5400rpm disk though while XP took minutes.

It was real real rough

Imagine gnome but instead of deciding your settings for you, they had a dialog where you had to pick the settings yourself.

You spent a few evenings downloading a hundred or so 1.44MB floppy imges over a 56kbps modem. You then booted the installer off one of those floppies, selected what software you wanted installed and started feeding your machine the stack of floppies one by one.

Once that was complete you needed to install the Linux boot loader “LiLo” to allow you the boot it (or your other OS) at power on.

All of that would get you to the point where you had a text mode login prompt. To get anything more you needed to gather together a lot of detailed information about your hardware and start configuring software to tell it about it. For example, to get XFree86 running you needed to know

• what graphics chip you had
• how much memory it had
• which clock generator it used
• which RAMDAC was on the board
• what video timings your monitor supported
• the polarity of the sync signals for each graphics mode

This level of detail was needed with every little thing

• how many heads and cylinders do your hard drives have
• which ports and irqs did your soundcard use
• was it sound blaster compatible or some other protocol
• what speeds did your modem support
• does it need any special setup codes
• what protocol did your ISP use over the phone line
• what was the procedure to setup an tear down a network link over it

The advent of PCI and USB made things a lot better. Now things were discoverable, and software could auto-configure itself a lot of the time because there were standard ways to ask for information about what was connected.

On the topic, did AOL work on linux? They were the google of their time, i can’t imagine the FOSS world thought very highly of them

Relevant xkcd’s

I didn’t have a Pentium processor in my computer, the internet was young, information wasn’t as ready or available, and the mindset wasn’t that you could check everything. I don’t remember how many floppy disks it took to install Slackware, but at least one read error was definitely on the way. I had a 56k modem at home, so I had printed out the installation instructions from work. Compiling everything wasn’t a problem, because I learned to code back in 1983. When I tried to figure out the refresh rate of my screen, I was afraid I would blow it up and go blind. The feeling of freedom was when you were the one who could choose everything for the first time in your virtual life.

The first time I ever used Linux was in high school around 2001-2002. I don’t remember what the distro was but it had drawing issues, clearly some kind of driver issue that I couldn’t figure out, on my PC so I switched back to Windows 98SE.

Not what op asked for, but it kept away from Linux at home until 2007. I started using Linux regularly in university around 2004.

All I know is I wish I would’ve stuck with it when I first installed but…alas…I was lazy and too dependent on GUI

Hmm my first linux distro was Suse 5.x that came on 5 CDs (i think it was 1998) … can’t say I used it much, I had weird German ISDN Internet at the time and the PPPoverWhatever (forgot the exact name) just didn’t wanna work. Making music wasn’t really feasible at the time. It mostly lay dormant. I slowly climbed the learning curve and switched to Linux full-time in the mid-2000s, when a lot more things were possible …

Games: xbill, koules, and quake1 prerelease test(8 or 16 player multi)

Crafting XFree86 config lines to get a monitor working(no auto-detect for resolution modes)

Sharing tips, on how to solve all these issues, with others at Linux User Groups(LUGs)

Contrary to other OSes, the information about it was mainly on the internet, no books or magazines. With only one computer at most homes, and no other internet-connected devices, that posed a problem when something didn’t work.

It took me weeks to write a working X11 config on my computer, finding all the hsync/vsync values that worked by rebooting back and forth. And the result was very underwhelming, just a terminal in an immovable window. I think I figured out how to install a window manager but lost all patience before getting to a working DE. Days and days of fiddling and learning.

The only OS that was solid as a desktop OS back then, with good usability, was BeOS. Both MacOS and Windows had stability problems (although NT/2000 were much better, but lacked app/game compatibility), and Linux was a nightmare to update and run (lots of compiling too). So the OS of choice back then for me, was BeOS. I could do everything I needed with it too.

I got tired of compiling the kernel taking a day on my Pentium pc. So I got a pile of 486s the uni was throwing out, built a Beowulf cluster out of them and soon I was able to compile the kernel in two and half days.

If you wanted to run Unix, your main choices were workstations (Sun, Silicon Graphics, Apollo, IBM RS/6000), or servers (DEC, IBM) They all ran different flavors of BSD or System-V unix and weren’t compatible with each other. Third-party software packages had to be ported and compiled for each one.

On x86 machines, you mainly had commercial SCO, Xenix, and Novell’s UnixWare. Their main advantage was that they ran on slightly cheaper hardware (< $10K, instead of $30-50K), but they only worked on very specifically configured hardware.

Then along came Minix, which showed a clean non-AT&T version of Unix was doable. It was 16-bit, though, and mainly ended up as a learning tool. But it really goosed the idea of an open-source OS not beholden to System V. AT&T had sued BSD which scared off a lot of startup adoption and limited Unix to those with deep pockets. Once AT&T lost the case, things opened up.

Shortly after that Linux came out. It ran on 32-bit 386es, was a clean-room build, and fully open source, so AT&T couldn’t lay claim to it. FSF was also working on their own open-source version of unix called GNU Hurd, but Linux caught fire and that was that.

The thing about running on PCs was that there were so many variations on hardware (disk controllers, display cards, sound cards, networking boards, even serial interfaces).

Windows was trying to corral all this crazy variety into a uniform driver interface, but you still needed a custom driver, delivered on a floppy, that you had to install after mounting the board. And if the driver didn’t match your DOS or Windows OS version, tough luck.

Along came Linux, eventually having a way to support pluggable device drivers. I remember having to rebuild the OS from scratch with every little change. Eventually, a lot of settings moved into config files instead of #defines (which would require a rebuild). And once there was dynamic library loading, you didn’t even have to reboot to update drivers.

The number of people who would write and post up device drivers just exploded, so you could put together a decent machine with cheaper, commodity components. Some enlightened hardware vendors started releasing with both Windows and Linux drivers (I had friends who made a good living writing those Linux drivers).

Later, with Apache web server and databases like MySql and Postgres, Linux started getting adopted in data centers. But on the desktop, it was mostly for people comfortable in terminal. X was ported, but it wasn’t until RedHat came around that I remember doing much with UIs. And those looked pretty janky compared to what you saw on NeXTStep or SGI.

Eventually, people got Linux working on brand name hardware like Dell and HPs, so you didn’t have to learn how to assemble PCs from scratch. But Microsoft tied these vendors so if you bought their hardware, you also had to pay for a copy of Windows, even if you didn’t want to run it. It took a government case against Microsoft before hardware makers were allowed to offer systems with Linux preloaded and without the Windows tax. That’s when things really took off.

It’s been amazing watching things grow, and software like LibreOffice, Wayland, and SNAP help move things into the mainstream. If it wasn’t for Linux virtualization, we wouldn’t have cloud computing. And now, with Steam Deck, you have a new generation of people learning about Linux.

PS, this is all from memory. If I got any of it wrong, hopefully somebody will correct it.

Stuff needed tweaking more wine worked almost never even for basically window’s programs. Configuring Xfree86 was black magic. Running Startx at the terminal prompt was like rolling the dice. Distro choice was smaller and it was really a choice. Since the child distros were less of a thing. You had Debian , Redhat, Slackware, and SUSE. All were very different at a fundamental level with packaging and philosophy. Also it was way more common to buy boxed copies of Linux distros with big thick manuals that helped you get it installed and take your first steps with Linux. It reminded me of when I first got my TI 83 calculator an it had that massive manual with it.

Also Lugs and spending a lot of time on IRC getting and helping people on freenode (don’t go there now) was a must.